Using network adopter connected to HUB #1 via BridgingĮven though I guessed that connecting to home WiFi directly, the modem will handle the traffic not any of PCs on the LAN but it was worth the try. How I assign IP address from SE server Hub #1 my phone? Still I am learning L2 Switch so I tried the second scenario.īecause I needed to add a second network adopter. using IP route or maybe iproute PBC (Policy Based Routing) a cascade connection from HUB #2 to remote SE server two Local Bridge for each HUB, first HUB a network adopter, second HUB a tap device ![]() a cascade connection in second HUB #2 to a remote SE server two HUBs one for internal net and one for external net The funny part is that a pi here (Iran) is more expensive than a PC (e.g HP ProDesk G4 :| :| :| )Īnd when I connect my phone to the modem WiFi I should have been connected to the remote VPN server. If we have a "raspberry pi box" we can connect to it via its network port, setup a VPN server on it, share the internet via pi WiFi access point the most convenient way of having Internet over a VPN which is 24/7 up and running. It annoys me each time I connect my phone to the home modem WiFi I have to turn on a VPN (on my phone) to check sites/apps have been blocked or for privacy. ![]() I have been holding this question in mind for the past few months.
0 Comments
Leave a Reply. |